Maratac Brass AAA Flashlight

WORLDS FIRST PRODUCTION LED BRASS FLASHLIGHT...THE SMALLEST, BRIGHTEST, AAA FLASHLIGHT? WE THINK SO!

NEW FOR 2018 - NICHIA 219C WITH A LIFESPAN UP TO 50,000 HOURS. ( NEWEST & BRIGHTEST EMITTER )

Check out this AAA powerhouse.

After thousands of Request ( Medium / Low / High )

Specifications:

• Executive Series
• Glow in the dark Diffuser ( New for Rev 3 )
• Glow in the Dark front o-ring around reflector ( New for Rev 3 )
• Each light is hand finished.
• Length: 2.6" ( Smaller than Rev 1 )
• Diameter: .5"
• Weight with battery is 37.3 grams ( 28.1 grams without battery )
• LED Type: Nichia 219C with a lifespan up to 50,000 hours. ( Newest & Brightest Emitter )
  * Now with the same ultra-low thermal resistance as Cree
• The New Orange Peel Reflector is aluminum alloy.
• Flashlight body is machined of solid billet ultra conductive C360 Free Machining Brass ( Buttery Smooth ) Brass.
• The lens has been treated with an AR (anti-reflective) coating.
• Its proprietary circuit design features reverse polarity protection and runs off of one AAA battery that provides
• Now with 3 levels of brightness ( Medium - Low - High ).
• Comes with clip & o-rings
• Note: this is a solid Brass flashlight not plated
• Clip installed from factory to preserve finish
• New Stronger Clip

Using a single Duracell AAA battery we got the following results:

• Medium mode, 48 lumens output for up to 8 hours
• Low mode, 1.5 lumens output for up to 65 hours
• High mode, 170 lumens output for up to 75 minutes
• ( Rev 1 model was 80 Lumens and 48 minutes) ( Rev 2 model was 115 Lumens and 60 minutes)

Use the charging C360 Free Machining Brass ( Buttery Smooth ) head to charge the light and you're all set to keep on trekking.

Can be charged from work, home, laptop, USB Battery pack....

Specifications: 

• Length: 1.6" Diameter: .74" Weight: 27.8 Grams - No Battery 
• Battery weight 9 Grams
• Comes with extra o-rings
• LED Type: Cree XP-G2 S4 with a life span up to 50,000 hours. ( Newest & Brightest Emitter )
• Orange Peel Reflector for a smooth even beam
• Recharge Time is 30-100 minutes - depending on charge rate source
• The reflector is aluminum alloy.
• Flashlight body is made of C360 Free Machining Brass ( Buttery Smooth )
• Battery is 14250 Lithium Cell 280mAh
• The lens has been treated with a AR (Anti-Reflective) coating.
• Its proprietary circuit design features reverse polarity protection and runs off of one 14250 battery that provides 2 levels of brightness (Low / High).
  • Twist on for Low
  • Twist 1/2 turn more for High

Using a single 14250 battery we got the following results:

• Low mode, 15 lumens output for up to 9 hours

• High mode, 305 lumens output for up to 40 minutes

Includes Complete Kit:

1x Lithium Rechargable Battery
1x USB Charging Cable 
1x Charging SS Head With Charge indicator
1x PCL Light C360 Solid Brass Head & Body
4x Spare O-Rings

The possibilities are endless of what this tool can carry! AA battery, geo-caching, pet identification, emergency cash stash, water purification tablets storm proof matches, cotton balls for fire starting, pills, needle, thread, etc. One side of the Tube-A-Ton is a battery locker which fits AA batteries perfectly. Brand new, never used overrun from government contract. Each side has a tight o-ring seal to prevent exposure to moisture in the toughest conditions. Has large loop hole for attaching lanyards and split rings for EDC (Every Day Carry).

Tube-A-Ton fits a AA on each side !

The possibilities are endless!

TITANIUM MODEL SPECS

Overall length: 159.00 mm or 6.17
External diameter: 19.00 mm or .75"
Internal opening: 14.45 mm or .57"
Internal depth: 49.00 mm or 1.95" & 69.2 mm or 2.72"
Lid is secured via flange to cap seal (internal o-ring)

Titanium : 6AL-4V

Weight :102.5 Grams

EOD Robotics developed this compact breaching tool with input from Bomb Techs, SWAT Operators and Patrol Officers. All these folks need a tool for prying, cutting and pounding, and here's the answer.

Specifications:

• Made from 1045 high carbon steel and fully heat treated to a Rockwell hardness of over 45.
• The EOD Robotics Breacher Bar & CERT Bar come ready to go as a pry bar or lever. Ideal for opening crates and even punching through steel drums etc. The coffin corner back edge lends itself to a hammer nicely.
• The 2 inner holes in the handle can be for paracord or solid slabs or whatever you like. The hole towards the top of the blade and the one on the end are good for lashing it onto a shaft, tree branch etc. The end hole is geared for hanging it up or for attaching a lanyard so you do not lose it in that pit or in the water.
• The top edge can be hammered on as can the back end. And then you can use your imagination to do other things with it. (Makes a good wood chisel too!).
• Bars do not come with cord wrapped handles. You will receive the metal bar. The rest is up to you.
• Not pretty, but pretty handy. These were bulk packed for shipment to the military so they may have some rub marks where they have rubbed together in transit.
• Made in USA

Here's What Our Over-Protective Legal Department Has To Say:
Although the EOD Breacher Tool was developed and designed to enter the real world of urban combat, and with a little work with a file, belt sander, grinder, stone or a rock to it could be sharpened and converted to a Deadly stabbing or slashing instrument we can't recommend it. Likewise, the flat on the handle end should not be used as a skull or rib crusher or for performing other blunt trauma. Sorry these are not returnable. Be safe, and don't play with matches or run with scissors.

The Flat Gate Clip can be used to keep your everyday carry gear organized and ready for rapid deployment. The Flat Gate Clip is Water Jet cut and is truly made to last and can be used to carry any small preppers paraphernalia you may have.

Specifications:

       Small 20 mm x 9.25mm x 3mm ( 3.2 Grams )
       Medium 26mm x 12mm x 3mm ( 5.1 Grams )
       Large 33mm x 15mm x 4 mm ( 7 Grams )

• Made from 300 series stainless steel

IMPORTANT : This is not a life safety device.