Maratac Brass AAA Flashlight

WORLDS FIRST PRODUCTION LED BRASS FLASHLIGHT...THE SMALLEST, BRIGHTEST, AAA FLASHLIGHT? WE THINK SO!

NEW FOR 2018 - NICHIA 219C WITH A LIFESPAN UP TO 50,000 HOURS. ( NEWEST & BRIGHTEST EMITTER )

Check out this AAA powerhouse.

After thousands of Request ( Medium / Low / High )

Specifications:

• Executive Series
• Glow in the dark Diffuser ( New for Rev 3 )
• Glow in the Dark front o-ring around reflector ( New for Rev 3 )
• Each light is hand finished.
• Length: 2.6" ( Smaller than Rev 1 )
• Diameter: .5"
• Weight with battery is 37.3 grams ( 28.1 grams without battery )
• LED Type: Nichia 219C with a lifespan up to 50,000 hours. ( Newest & Brightest Emitter )
  * Now with the same ultra-low thermal resistance as Cree
• The New Orange Peel Reflector is aluminum alloy.
• Flashlight body is machined of solid billet ultra conductive C360 Free Machining Brass ( Buttery Smooth ) Brass.
• The lens has been treated with an AR (anti-reflective) coating.
• Its proprietary circuit design features reverse polarity protection and runs off of one AAA battery that provides
• Now with 3 levels of brightness ( Medium - Low - High ).
• Comes with clip & o-rings
• Note: this is a solid Brass flashlight not plated
• Clip installed from factory to preserve finish
• New Stronger Clip

Using a single Duracell AAA battery we got the following results:

• Medium mode, 48 lumens output for up to 8 hours
• Low mode, 1.5 lumens output for up to 65 hours
• High mode, 170 lumens output for up to 75 minutes
• ( Rev 1 model was 80 Lumens and 48 minutes) ( Rev 2 model was 115 Lumens and 60 minutes)

Proudly U.S.A Made!

When Uncle Sam requested a small pocket pry bar for technicians to open ordinance crates in the field, this was offered as the solution. The Widgy Pry Bar is made to fill the high demand for a customizable widgy bar which you can sharpen into your own EDC tool. These compact bars are heat treated D-9 steel and provide a common sense solution to broken knife blades and bent screw driver shafts. These are first run extras from government order.

The Flat Gate Clip can be used to keep your everyday carry gear organized and ready for rapid deployment. The Flat Gate Clip is Water Jet cut and is truly made to last and can be used to carry any small preppers paraphernalia you may have.

Specifications:

       Small 20 mm x 9.25mm x 3mm ( 3.2 Grams )
       Medium 26mm x 12mm x 3mm ( 5.1 Grams )
       Large 33mm x 15mm x 4 mm ( 7 Grams )

• Made from 300 series stainless steel

IMPORTANT : This is not a life safety device.

Proudly U.S.A Made!

When Uncle Sam requested a small pocket pry bar for technicians to open ordinance crates in the field, we offered these as the solution. The Widgy Pry Bar is made to fill the high demand for a customizable widgy bar which you can sharpen into your own EDC tool. These compact bars are heat treated D-9 steel and provide a common sense solution to broken knife blades and bent screw driver shafts. These are first run extras from our government order.

385 Lumens!!! New even flow beam

Glow O-ring Around The Reflector ( easy to find in the dark )

Black Powder Coat Pocket Rotating Pocket Clip

The light is straightforward to use and has friendly ergonomics. The Maratac AAAx2 Extreme features an advance Cree XP-G2(R5) LED for greater brightness and efficiency.

•  Medium 45 Lumens / Low 5 lumens / High 385 lumens  mode brightness control (Simple 3 mode switching)
• Operation:
  • Press and click the back thumb switch to turn on the light into Medium mode. Lightly press again for Low mode and once more for High. Press and click anytime to turn the light off.

SPECIFICATIONS:

• 22.8 grams or .8 oz (without battery)
• 5.0" O.A.L. x .58" inch width
• Type 3 Military Grade Anodizing ( Matte Finish )
• Utilizes 2 Standard AAA Batteries ( 1.2-1.7 Volts each )
• Standard Modes ( Pressing Tail Cap Through Modes )
• • Medium ( 6 Hours )
  • Low ( 90 hours )
  • High ( 1.65 hours )

The Hults Bruk Aneby is a stout medium sized axe.

A great axe for camping or hunting designed to offer considerable power and leverage in a compact size. Ideally suited for light forest work, splitting smaller firewood and felling smaller sized trees. The Aneby can be comfortably used with one hand or both hands, and features a rounded poll for skinning. This item has an axe head weight of 2 Lbs and a handle length of 20 inches.

• The axe head is hand-forged and made from Swedish axe steel in a foundry that has been in operation since 1697.
• As part of the hand grinding production process, the steel is struck multiple times thereby increasing its density and resulting in more durability of the axe.
• The head is constructed in such a way that there is a tempered zone designed to hold a very sharp edge even after many sharpenings.
• The curved hickory handle is treated with linseed oil.
• Each axe comes with a traditional leather protective sheath. (Replacement sheaths are available) The axe is shipped in its own storage box and comes with a detailed users manual.